Press and hold the Mode/Reset button for 3 seconds until the error disappears. If the error returns within 24 hours, call a technician. 10. Flue System Requirements The Lambert LX 24 FI is approved for concentric flue (60/100 mm) or twin pipe (80/80 mm) with adaptor.
A: Yes. The LX 24 FI works with volt-free (230V) or OpenTherm thermostats. Use terminals 3-4 for OpenTherm (if supported) or 1-2 for on/off. lambert lx 24 fi instrukcia
This long-form article serves as a complete instruction manual (instrukcia) covering installation prerequisites, control panel operation, daily use, parameter settings, maintenance schedules, error codes, and safety precautions. Always refer to the official Lambert documentation supplied with your unit, as regional gas and water regulations may vary. | Parameter | Value | |-----------|-------| | Type | C13, C33, C53 (concentric flue) | | Max heat output (heating) | 24 kW | | Min heat output (heating) | 5.4 kW | | DHW output (max) | 24 kW | | Efficiency class (heating) | ★★★ (ErP) | | NOx class | Class 6 | | DHW flow rate (ΔT=30°C) | ~11.4 l/min | | Inlet gas pressure (G20) | 20 mbar | | Electrical supply | 230V ~ 50Hz | | Power consumption | ~110 W | | IP rating | IPX4D | | Expansion vessel capacity | 6 l (pre-charge 1 bar) | | Max heating pressure | 3 bar | | DHW range | 30–60°C | | Heating flow temp range | 20–85°C | Press and hold the Mode/Reset button for 3
Introduction The Lambert LX 24 FI is a wall-hung, gas-fired condensing boiler designed for residential heating and domestic hot water (DHW) production. The "FI" designation typically indicates a forced flue (fan-assisted) model with a fully integrated electronic management system. This boiler is part of Lambert’s next-generation LX series, known for energy efficiency (ErP compliant), low NOx emissions, and compact design. Flue System Requirements The Lambert LX 24 FI