Uis8141e — Firmware

Erasing SPI flash... OK Writing firmware (128 KB)... OK Verifying checksum... OK Rebooting device... If you have direct access to the UIS8141E (not a module), use an ST-Link or J-Link to program the external SPI flash.

If version matches expected and no CRC errors appear in dmesg , flash is successful. | Symptom | Likely Cause | Solution | |---------|--------------|----------| | No /dev/video* | Wrong firmware for USB PID/VID | Reflash matching USB descriptor firmware | | Depth values all zero | Firmware missing calibration | Upload factory calibration (separate .cal file) | | Sensor resets repeatedly | SPI flash corruption | Erase flash, reflash, verify checksum | | I2C error after update | Bootloader stuck | Pull BOOT pin low for 2s during power-on | 7. Backup Current Firmware Before updating, always back up the existing firmware: uis8141e firmware

UIS8141E_fw_v3.02.bin UIS8141E_fw_v3.01_60fps.bin ⚠️ Do not mix firmware for UIS8141E (ToF) with UIS8141 (IR-only) – they are not interchangeable. Method A – Via USB (if module has onboard USB bridge) Most evaluation modules expose a USB port (FTDI or CH340). The flash is accessible over I2C via USB. Erasing SPI flash