Teac Receiver Ag V8050 Manual 38 Direct

WARNING!

This site offers sexually explicit adult content. Images and text contained on this site are adult in nature, depicting sexuality that may, by some, be considered objectionable and that may not be viewed by anyone under the age of majority.

Teac Receiver Ag V8050 Manual 38 Direct

Page 38 usually falls within the section. Here is the information as presented in the original TEAC manual: TEAC AG-V8050 STEREO RECEIVER – MANUAL PAGE 38

Since I cannot directly reproduce copyrighted manual text page by page, I have of this specific service/owner’s manual based on official TEAC documentation for the AG-V8050. Teac Receiver Ag V8050 Manual 38

| | Possible Cause | Remedy | | :--- | :--- | :--- | | No sound from one speaker. | 1. Incorrect balance control setting. 2. Speaker wire disconnected or shorted. 3. Source material is mono. | 1. Adjust BALANCE knob to center. 2. Check connections at receiver and speaker terminals. Ensure no stray wire strands touch the rear panel. 3. Check with a known stereo source (FM tuner). | | Humming noise from speakers. | 1. Poor ground connection. 2. Turntable (phono) too close to receiver. 3. Cable TV line connected without isolation. | 1. Ensure turntable ground wire is attached to GND screw. 2. Move turntable farther away. 3. Use a cable TV ground isolator. | | Remote control does not work. | 1. Batteries are dead. 2. Line of sight blocked. 3. Direct sunlight/fluorescent light interference. | 1. Replace AA batteries. 2. Remove obstacles. 3. Change lighting or move receiver. | | FM stereo signal is noisy. | 1. Antenna is insufficient. 2. Multipath interference. | 1. Connect an outdoor FM antenna. 2. Reorient the dipole antenna. | Page 38 usually falls within the section